A clear aligner case has three parts, set out below as six stages. Before planning: consultation, clinical examination and records. Then planning and manufacture, which with American Aligners is four steps: upload scans and images, an orthodontist designs the plan, the dentist approves it, and the aligners are delivered. After delivery: fitting, attachments, monitoring, refinements if needed, and retention. The treating dentist is responsible at every stage.
Key takeaways
- Active treatment should not start before an in-person clinical exam and diagnostic records, according to the British Orthodontic Society (BOS).
- The dentist who approves the plan owns the clinical decision, even when relying on diagnostic information from another source.
- The first aligners should ideally be fitted in the clinic by a member of the dental team.
- Wear time is about 22 hours a day, as the dentist prescribes, and a new aligner usually follows every one to two weeks.
- The retainer is part of the plan from day one, not an add-on at the end.
Stage 1: Consultation and records
The case starts with the patient’s concern and expectations, then a clinical exam of teeth and gums and of whether aligners suit the case. The American Association of Orthodontists (AAO) states that dental work must be completed before scanning, and that diagnosis draws on radiographs, photographs and digital scans. Teeth can be recorded with a scanner or with conventional impression material.
We set out the readiness checklist in what dentists need before offering clear aligners, and accept-or-refer criteria in suitable cases and when to refer.
Stage 2: The four steps with American Aligners
| Step | Who | What happens |
|---|---|---|
| 1. Upload scans and images | The dentist’s clinic | The case scans and photographs are submitted |
| 2. Plan design | An orthodontist | A digital plan setting out which tooth moves where, and in what order |
| 3. Plan approval | The treating dentist | The plan is reviewed and approved before manufacture |
| 4. Aligner delivery | American Aligners | The aligners are made and delivered to the clinic |
Approval is not a formality. BOS guidance says that a clinician relying on diagnostic information from other sources carries sole responsibility for the clinical decisions based on it. Compare the plan with your own exam and records before you approve it. We explain how to read a digital plan, and its limits, in digital treatment planning and 3D scanning.
Stage 3: Fitting and attachments
BOS recommends that patients ideally visit the clinic to have their first aligners fitted by a dental professional. According to AAO, the fit appointment covers delivery of the aligners, placement of attachments, and wear and care instructions. Attachments are small tooth-coloured bumps bonded to some teeth to help the aligners move them. Depending on the plan, they may be placed at this visit or a few aligners later (BOS).
If the plan includes interproximal reduction (IPR), a technique that creates space for alignment by reducing enamel between teeth, BOS advises that the clinician responsible for the treatment plan carries it out. Patient instructions include:
- Wear the aligners about 22 hours a day, as the dentist prescribes.
- Take them out to eat and for any drink other than water; water is fine with the trays in.
- Expect mild pressure in the first days and again with each new tray; it is temporary and typically eases within a few days.
- Move to the next aligner usually every one to two weeks, as the dentist directs.
Stage 4: Monitoring
AAO recommends regular check-ups throughout treatment to make sure the teeth are moving appropriately, and notes that some practices offer remote monitoring. BOS says the treating dentist should actively monitor treatment, remotely or in person, without relying fully on automated tools.
When teeth fall behind the plan, start with compliance: AAO notes that success relies heavily on it, and that inconsistent wear can hinder progress, lengthen treatment or compromise the result.
Stage 5: Refinements
A refinement is an additional series of aligners to complete movements that were not achieved as planned. In a 2026 study of 40 adults with mild to moderate crowding, the first series of aligners did not achieve the planned alignment of the front teeth, and the authors recommended refinements. A scoping review reports that refinements were needed in over half of cases, noting that this rests on limited studies, largely of one aligner brand. Orthodontic elastics can also be combined with aligners when needed.
Tell the patient from the start that a refinement is a possible part of treatment, not a sign of failure.
Stage 6: Retention
After any aligner treatment, the patient will need a retainer to hold the teeth in their new position (BOS and AAO). BOS recommends a period of supervised retention, and advises explaining retainers at the start of treatment, including the likely need for lifelong wear. There is no recognised duration for retainer wear, and a Cochrane review does not settle the best retention method, so the decision stays with the treating dentist, case by case.
Frequently asked questions
Who carries clinical responsibility if another specialist designs the plan?
The treating dentist who approves the plan and provides the treatment. Under BOS guidance, responsibility for decisions based on diagnostic information from other sources rests solely with the prescribing clinician.
Can all reviews be done remotely?
Some reviews can be remote, at the dentist’s discretion, provided the dentist actively monitors the case, calls the patient in when needed, and does not rely fully on automated tools.
What should I do if the teeth are not tracking to the plan?
Check wear time first, then attachments and aligner fit. If the gap remains, a refinement is a common step in this kind of treatment.
When does retention start, and how long does it last?
It starts at the end of active treatment. There is no recognised duration for retainer wear; the dentist sets it for each patient and, as BOS advises, explains retainers at the start of treatment, including the likely need for lifelong wear.
Get started with American Aligners
To use this workflow in your clinic, see the steps and products on our products, then register on the become a provider page.
